How to remove scale in the washing machine?

When buying a new washing machine, it is always expected that this equipment will last a long time and will not fail. Unfortunately, on household appliances in six months there are traces of scum. If you do not clean the appliance in time from lime inclusions, they can bring the washing equipment to the state of unfitness. In this article, we will look at how to remove the scum in the washing machine and the basic means for this procedure.

to content ↑

We are looking for a scum

Scale is the deposition of salts on the heating elements of a household unit. The main reason for the formation of calcareous plaque is too hard water, in which there is a large amount of magnesium and calcium ions. Very often scum disturbs residents of urban apartments connected to a common riser pipe.

In addition, lime inclusions appear in the washing unit, when the washing process is accompanied by increased use of mineral and chemical substances. The remains of such components are deposited on the TEN and have a destructive effect on the details of household appliances.

Important! It is undesirable to constantly perform the washing process in the "intensive" mode. The program launched increases the percentage of salts that fall on the heater, as a result of which they quickly harden and problems arise.

You can check the presence of scale in the washing unit. As a rule, the heating element is placed directly under the drum, in some models it is displaced relative to the central plane in one of the sides. Using a flashlight, you can see the heating element in the hole on the drum.

Important! For uniform lighting, you need to shake the drum unit slightly. It does not happen right away - you need to experiment for some time with the speed of rocking.

to the contents ↑

What harm does the scale cause to the washing machine?

• Presence of scale significantly reduces the service life of washing equipment, at least twice.
• A lime-coated heating element is significantly less efficient than heat.
• TEN not only heats water more slowly, resulting in a loss of electricity, but it itself overheats.
• The internal contamination of the washing unit leads to clogging of the exhaust valve, which starts to drain water worse and disables the equipment.

Important! If you make improper cleaning of the automatic machine or use inappropriate means, then after such a procedure, lime inclusions on the heating element appear with a new force and much faster. Therefore, it is necessary to ask in advance how to properly remove scale in the washing machine.

Any breakdown requires the intervention of a qualified technician and if household appliances are not on warranty service, then it will be very expensive to pay for the services of the master.

to the contents ↑

How to clean the washing machine from scale and prevent its occurrence in the future?

How do I clean the washing machine of scale in the home? There are two ways to remove limescale on the heating element. You can solve this problem yourself or call a household appliance specialist:

• The first option is much more complicated, since you need to think everything over, stock up on the necessary means and proceed with a careful descaling procedure.
• The second method is much more expensive, but it will not always be reliable. Not all masters can provide expert assistance.

Most methods do not imply mechanical action, but it is better to have a clean rag, a good loofah, rubber gloves on hand. Not only does the scum pollute the automatic machine, but clumps of dirt interfere with the full functioning of the washing unit.

Important! It is best to remove dirt from the washing unit using rags made of microfiber, which excellently absorb liquid and do not leave any streaks.

You need to be prepared for the fact that you have to disassemble the washing equipment, because there is no other way to get rid of the scum. Therefore, just in case you need to have at hand instructions for using the washing unit.

Citric acid

Citric acid helps to clean the washing equipment of lime deposits:

• If it is necessary to wash very often, then this procedure should be performed once in three months.
• If the automatic machine is rarely used, then the cleaning is applied once in six months.

How to descale the washing machine with citric acid:

1. In the detergent container, cover 50-100 g of citric acid.
2. We start the wash mode "without laundry" and set the temperature mode to 70-80 degrees.

Important! In addition to descaling, this method eliminates foreign smells. Such prevention does not cause any harm to the details of washing equipment - this has been checked repeatedly.

"Antinakipin"

With already appeared lime coating, it is possible to fight using the chemical agent "Antinakipin".The principle of operation of such a substance is very similar to that of citric acid, only this drug is much more expensive.

For descaling, it is necessary to perform the following actions:

1. We buy the pack of "Antinakipin" into the powder container, while observing the required amount specified in the instructions.
2. We start the idle wash mode. When heated, a chemical reaction occurs, which removes the scaling layer from the heating elements of the device.
3. It is advisable to select a program with a wash duration of no more than 60-70 minutes.

Important!"Antinakipin" has strong chemical properties, which are much stronger than citric acid, so with mismanagement, such a substance can damage household appliances. The disadvantage of this remedy is that if a large amount of "Antinakipin" is poured, then the rubber parts of household equipment may be corroded. As a result, the washing machine starts leaking and repairs are needed. In addition, the use of "Antinakipin" requires special care.

White vinegar

Clean the washing unit with white vinegar. Specialists note that it is the white vinegar used in cleaning the washing device, which is the most effective.

How to descale the washing machine with white vinegar:

1. In the washing equipment, pour two glasses of table vinegar.
2. We start washing in idling mode with the longest cycle, turn on the maximum temperature regime.
3. After 5 minutes, apply the "waiting" mode for an hour. Such a pause is necessary in order for the cleaning solution to penetrate all the hard-to-reach corners of the tank.
4. After the hour has elapsed, we start again the wash program, we bring the process to the end.
5. In order to wash off the remnants of the cleaning solution, you need to pour the water and run the program with a short wash.
6. Sponge dampened with a weak solution of vinegar, we wipe the doors of the machine from the inside, especially carefully we process rubber seals.

to content ↑

Prevention of softener problems

You can apply "physics" to prevent the formation of scale.

Magnetic Filters

In this case, the causes of limescale deposits are eliminated in advance, using a variety of water softeners based on a magnet. They are used directly on the washing hose of the washing machine or at the point where the pipeline enters the apartment. Such magnetic filter-softeners are called water converters.

Important! A magnetic water softener helps to purify water from calcium and magnesium. If these salts are absent, then there is no problem. The surface of the tank and the heating elements will no longer suffer from scale.

The principle of the action of strong magnets is that there is a splitting of calcareous deposits, or so-called calcite, into ions. As a result of this process, instead of calcite, aragonite is formed, which does not provoke any deposits. Passed through the wash tank, "magnetic water" does not contaminate the surface of both the tank and TEN.

Important! The disadvantage of this method is the high cost of the magnetic water converter. But this filter has a service life of about 50 years. After the purchase of a filter-softener, you can get rid of the problem of cleaning the washing equipment.

Sedimentary filters

In addition to magnetic water softeners, sediment filters are also used. These mechanical cleaning filters serve to remove pieces of rust and sand from the water. This procedure protects the pipes from clogging and helps prevent household equipment from damage. In addition, such filters extend the life of plumbing devices.

Technological method

What is the best way to clean the washing machine of scale and odor? It is possible to prevent the formation of calcareous plaque in a technological way.

Manufacturers of washing machines equip their equipment with new software modes, the water at which it heats only up to 40-50 degrees, and the quality of washing is excellent. Such a method allows not only to eliminate calcareous deposits, but also save considerable electricity.

Important! The hot water used for washing water, the more calcareous deposits are formed on the elements of the washer.

Manual cleaning of heating elements

It is possible to clean the heating element quickly and cheaply from lime deposits. To do this, use a manual method, which is called physical cleaning. In this case, it is necessary to disassemble the washing equipment and carefully take out the tubular electric heater from it. You can clean such an element with a special spatula.

Important! Carry out this cleaning with great care, as the electric heater can be damaged.

to the contents ↑

How to clean the filter of the washing machine?

The filter of the washing unit must be periodically cleaned, as the clogs provoke a breakdown of the washing equipment.

How to descale the washing machine filter at home:

• At the bottom of the washing unit, a filter is located in the special hatch. We open the hatch.

Important! Before the procedure of cleansing, it is necessary to lay under the washing technique a rag to remove dirty water. Also you need to stock up a basin for draining the water from the drain hose, which is located behind the panel that closes the filter device.

• Unscrew the filtering device.
• When the water has completely drained from the drain hose to the basin, remove the filter by turning it counterclockwise.
• Let's drain the rest of the water on a rag, only after that we get the filter.
• Inspect the impeller, remove all contaminants, as well as hair and fluff.
• Return the filter to its original location.

Important! The base itself, where the filtering device is located, is also subject to cleaning.

to the contents ↑

Why to clean the drum of the washing machine

In addition to the heating element, the drum of the washing unit is also exposed to lime inclusions. Modern models of household washing machines have a special function for cleaning the drum unit.

When a certain button is pressed, the program for cleaning the limescale is started, and the technician will cope with the task in hand. Unfortunately, most models of washing machines are not equipped with the appropriate function, and the owners of home appliances have to solve this problem on their own.

We recommend using this advice to eliminate traces of scale inside and inside the drum unit. You can use bleach, for this you need to perform the following actions:

1. 100 ml of this product is poured into the drum.
2. Run the program "without lingerie" with a temperature mode of about 60 degrees.

Application of this tool allows you to clean the drum device and eliminate all unpleasant smells.

Important! As a preventive measure, you should avoid the frequent process of washing fluffy and old clothes. Separate particles from the worn out things form a touch. To prevent such a problem, it is better to buy new products - thus extending the life of the washing unit.

In this article, you learned how to completely remove limescale in the washing machine from all its elements. Try one basic cycle, and you will notice how much the work of your home appliances has improved. And in the future you will already know exactly what and how to do to make the washing machine work long and well.