How to stretch the bootleg at home?

Very often, there are situations when, despite the fact that the shoes are quite heavy in the shin area. The question arises, how to stretch the bootleg at home. In no case can not tolerate a similar problem, because this, in the first place, is bad for health. Walking becomes incredibly painful because of the swelling of the extremities. Being in boots becomes unbearable.

In fact, if the shoes are made of thick material, stretch the bootleg is not difficult, it is only necessary to resort to some tricks. However, how to behave to girls who wear fine leather boots? About this now and talk. If you need to increase the boot, boots - you can do the job yourself.

to Contents ↑

Castor Oil

In most cases, this product is used to soften shoes from rough leather. Only a few know that this is also an excellent tool if you want to stretch the bootleg at home.

You need to proceed as follows:

1. Pour oil into a small container.
2. Preheat to 50 degrees.
3. Dampen with a liquid cotton pad or a small piece of cloth.
4. Wipe shoes from the outside and inside.
5. Put on your feet tights, socks or knee socks made of dense material. Then the boots.
6. In this form, it takes two to three hours.
7. Then repeat the procedure again.

Important! When the result is achieved, fill the shoes with paper until completely dry. Do not dry shoes with electrical appliances.

to the table of contents ↑

Rubber shoes

It happens, when it is necessary to stretch the boots in the boot of rubber - at home this problem can be solved, however, it is necessary to be very careful and attentive. If you feel that you can not cope, ask for help from relatives or contact the workshop.

It is necessary to operate from the inside, carefully making incisions. One of them must necessarily be centered, if the boots have an elastic band.

Important! If you need to cut rubber boots at home, you should also use this method.

to the contents ↑

Special tool for stretching

Method one - use a special tool for stretching shoes. Buy this compound can be in almost any store shoes and leather goods.

Important! This tool can also be used to prevent rubbing from a new pair of boots.

The use of such products is quite simple:

1. It is necessary to spray the preparation in the shin area inside and outside.
2. Fasten your shoes and stay in it for a while until it dries.

Important! This method is incredibly effective and good in that it is suitable for use as a shoe made from natural material, and from a leather substitute.

Special attention should be paid to suede and lacquer shoes. In this case, the agent should only be applied to the inner side. If you do not follow this advice, then the surface is guaranteed to form cracks, stains and stains.

to the contents ↑

Frozen water

For this method, it is necessary to pour water into a plastic bag of dense material, which is guaranteed not to break. Put it in your shoes and send a pair of boots to the freezer. Shoes should be there for about 3-4 hours, until the liquid freezes.

When the result is achieved, remove the boots from the freezer.

to the contents ↑

Iron

If there is such an opportunity, then ask someone from the environment to help you. So it will be much more convenient.

For this method you will need an iron and a small piece of gauze:

1. Place the unbuttoned boot on the unfolded ironing board with the zipper up.
2. Wet gauze and put it inside the shoe to the shin area.
3. Heat the iron.
4. Iron the product using a large amount of steam.
5. When the leather of the boots is heavily moistened, rather stretch the bootleg area with your hands. It is very important not to overdo it. Do this smoothly and evenly. Act neatly.
6. When the result is achieved, it is necessary to dry the shoes well. In this case it will take two or three days.

to the contents ↑

Newspaper

If you need to stretch the bootleg, then another great option is to stuff your shoes with something. You can use rags or newspapers, you can even use water-soaked croup.

Before the procedure, it is necessary to wet the boots with water equal to 50 degrees. In a few days, the result will pleasantly surprise you.

to the contents ↑

Sticks and glass jar:

1. Find the vessel that will be equal to the size of the shaft of your shoe.
2. Place it inside the boots, filling it with hot water and fasten the shoes to the lock.
3. Around encircle with sticks( place between the glass vessel and the shoe wall).

In this condition, the boots should be kept for several days until completely dry.

That's all. As you can see, reduce, enlarge, cut the bootleg is quite simple. It is worth a little try. Follow all the tips, methods and recommendations mentioned in this article, and you are guaranteed to succeed.