The complexity in the use of washing machines occurs when they crash. For example, when the washing machine is not collecting water. you can eliminate such damage himself, to determine the exact cause.
If the washing machine is not taking on water and buzzing, the reason may be in the wrong installation.
Check the connection of the drain, the water supply hose and included in the panel.
Before washing, read the instructions.
Problems are often caused by discharge in violation of rules of use of the washing machine.
The problem with the water supply
If the washing machine does not reach the water causes may be:
- The presence of water in the tap. The problem may be to rummaged plumbing or too low flow.
- a water supply hose. Check to see if it is open and it for any damage.
- Check hose filter, which protects the machine from small debris and dirt. To do this, disconnect the hose from the tank and inspect. If the filter is clogged, water can not flow into the tank or run slowly. Clean mechanism of rusty plaque and wash detergent.
Errors in the programming or control module
The reason for failure can be failures electronics machine-gun. Such problems occur after 3-4 years of use. In such cases, the valve is serviceable, but the technique does not give the command to set the water. To resolve the problem, contact the webmaster.
Broken valve for supplying water
This problem is a mechanical nature, arising out of:
- Burned winding;
- clogged filter;
- failure of the coil.
Check the operation of the intake valve:
- Disconnect the appliance and turn off the water.
- Remove the fastening of the top cover.
- Disconnect the wires from the coils.
- Remove the attachment to each of four tubes with a pair of pliers.
- Remove the screw and remove the internal valve.
- Put the new valve and tighten with a screwdriver.
- Attach the hose to the connectors, connect the wires.
- Place the lid of the washing machine.
- Turn on the machine, check its performance and let the water run.
If the new valve is connected correctly and the machine will begin to pour water into the drum, it is possible to start the wash.
Pressure meter
Pressostat or fluid pressure sensor - a module which detects and controls the amount of water entering the washing machine. When the sensor is not working properly, no water enters into the washing machine and the washing process will not start. It is necessary to completely change the pressure switch. Please contact the service center to the master.
hatchway locking apparatus
Damage to the hatch - one of the reasons that the washing machine does not fill with water.
Any laundry in stiralku well fix the door.
It has a plastic tab or guide is responsible for fixing the hatch can be broken. To solve the problem, remove the top cover or completely remove the door. Sometimes it is enough to replace it termoblokirovku.
Professional advice
To prolong the life of the washing machine, experts advise:
- If the machine dials and then drain the water, be certain the selected desired mode of operation.
- When malfunctions stiralki warranty, call a specialist. This will save time and money.
- Methods to resolve the breakdown detailed in the instructions.
- When disconnecting the hose from the water supply shut off the water.
All work is done with de-energized stiralka.
It often happens that the washing machine does not work, because it is no longer filled with water. The problem can be connected, the hose and serviceability tap water supply. If you've already repaired the equipment, try to repair themselves. But it is better to play it safe and give the car to be repaired.
