After a long time the effective use stiralki, it can be damaged. The display shows the system code, after which the equipment stops working. De Error in the washing machine lg easy to eliminate without the help of professionals. Enough to know the causes of code and technology of diagnosing the source of error.
What does the error de: causes of
To determine the type of fault, washing machine manufacturers have developed special codes. Lg brand used the code on the scoreboard, signaling device owner for damage. If the equipment produces an error on de LG washing machine is a problem with the hatch lock.
Stiralki without display report damage while blinking lights, "Temperature", "Wash" and "rinse".
Sometimes, to solve the problem fairly tightly against the door. The error code disappears from the display and the washing process starts. If that's not enough, consider other possible causes:
- breakage of the hook bolt, the locking elements of the hatch cover;
- bias spring wire clamp in the door lock system;
- failure hatch electronics;
- breakage sensor to start the machine.
These are the most common reasons when the washing machine lg de an error on the display. Do not risk techniques in an attempt to find other reasons without the help of the wizard.
Diagnosis source
Some types of failure of parts can not be corrected independently. This requires a competent diagnosis and replacement mechanisms.
When the washing machine lg an error de, there are ways to eliminate it at home:
- Check whether stiralka small parts. Prevent the closing of the door may linen in the opening of the hatch or rubber sleeve from its base.
- Inspect the opening of the hatch lock.
- Prokontruyte door hinges. Wear, "tongue" of the door can not penetrate into the castle.
- Check the control module. Unplug from the mains for 20 minutes.
If the washing machine LG continues to produce an error, perform a detailed diagnosis:
- Pay attention to the integrity and mobility hook blocker. If he's all right, mate pull locking device Okrut few screws.
- Remove the mechanism and turn on the machine. If the open hatch stiralka stop signal, replace the locking device.
With proper device lock hatch problem may be elektrokontrollera mechanism. To verify this, disassemble the equipment:
- Remove the plastic cover elektrokontrollera by prying a screwdriver.
- Disconnect the device from a large fee to display.
- Inspect a small fee for damages.
If a small control board noticeable fouling or damage to tracks, de cause of the error on the LG washing machine is found.
Repair without any professional assistance
To resolve this issue read de device of the washing machine and inventory tools.
| signs of damage | POSSIBLE CAUSE | Repair and replacement |
|---|---|---|
| Lit de error signal on the washing machine, the machine door is not closed, the lock indicator lights | Failure of the hatch locking device | Remove the rubber collar cuff, remove the connectors with wires, unscrew the locking device with a screwdriver and replace it with a new |
| In operation stiralka stops and outputs the error code, and the smell of burning felt | It has failed chip display unit | Fault display unit may indicate problems with the switch, blocking the door, or blown tracks microplate. Eliminate the carbon deposits (clean a small fee), Solder again or change completely |
| The handle lock is not turned on the display illuminated letters de | The problem with the lock handle | Remove the mounting of the door by separating its half with a screwdriver. Then, remove the handle and install it in a new spring. |
| The apparent damage to the access door | Broken hinge washing machine hatch | Tighten or adjust the screws to secure. |
De error may indicate a problem with the door lock LG drum washing machine. Before repairing carry out a thorough diagnosis of all door lock mechanisms. In case of serious damage, refer to the master.
