The drum is filled with linens and soapy water, but the machine hangs and displays a strange code in the form of two letters: OE. Error OE in a washing machine LG when you run the program. We decipher what lies behind the two letters, which can lead to errors and how to fix any damage.
What does the error OE: causes of
If the program involved the drain pump to remove the water, but it remains in the drum washing machine LG displays the message: «oe mistake."
Error means no discharge of water from the drum machine.
The program provides independent attempts to remedy the situation.
The machine can perform up to 7 retries the water drain. If after this equipment detects availability of water in the tank, the machine stops and an error th.
LG's experts identified a number of causes of the error:
- Overlapping drainage systems, filters or hoses, marked blocked.
- Clogging of sewage system, siphon sink, a sewer pipe.
- Failure of the drain pump.
- The defect of the water level sensor.
- Defect programmer or elektrokontrollera - chip, which controls the operation of the washing machine. In case of error fade elements responsible for draining.
About breakage elektrokontrollera system not only informs the issuance of the OE signal. The defect has manifested exhibiting different modes of washing.
Breakage might not be within stiralki. Examine the state of the sewer system is cheaper search internal problems.
Clogging can be determined by water outflow speed otkruchennyh hot and cold taps.
Fault error source
If the machine lg threw error 0e, you can determine the cause and correct the malfunction. To do this, remove blockages in accessible locations and cross-check junk filter.
If the filter is clean, check the drain hose. Shut off the water outflow can weed stopper or kinked hose. Faults easily identified and eliminated.
LG direct connection of the drain hose from the machine sewage inspect the place of transition of the hose into the sewer pipe. As a result, clogging of water flow turbulence are formed here. Do not forget to explore the accessible part of the sewer pipe.
Disconnect the hose and rinse with running water. For removing mud plugs use a long steel wire bent in the shape of a hook. If the hose is clean, you can begin to search intraengine reasons.
The drain pump in the washing machine lg is very noisy during the spin cycle. If the characteristic of the noise is not present, the error may be the reason the pump. Check pump filter contamination, the filter removing the hatch in the lower part of the front panel.
Faulty water level sensor and the control board can also lead to the OE error. Do not repair yourself electronics without experience and equipment. To restore the operation of the controller, switch off the machine from the wall outlet for 30 minutes. Volatile elektrokontroller can throw new installation and after switching to restore their initial level.
How to remove yourself
Tips to eliminate sources of error th:
- Osmatrite and clean the drain filter. Remove all the detected coins, paper clips and small laundry.
- A clogged drain hose disconnect and hot water wash under pressure.
- Clogged siphon disassemble and clean the parts.
- To check the electrical, voltmeter, measure the voltage at the terminals of the sensor pressure switch and drain pump. Sequential sensors disconnect and re-enable the machine. If this technique does not work, replace the equipment.
- If the CPU of the control board is not damaged, replace lost items. Solder burnt track. If damage affected processor, replace the control unit.
- Pressure switch monitors the water level in the drum. If the machine does not determine the water in the drum and merges it may be zosor in the tube. For cleaning just blow it. If after cleaning the situation has not changed, replace the sensor.
If the machine suddenly stopped working and displays a diagnostic error th - do not panic. Learn the value of the fault code, 50% of the issue is resolved on its own.
