Different types of coffee makers are constantly maintained equipment. If the coffee machine broke down, so does the schedule of cases. It is difficult to work in a familiar rhythm, not the usual drinking morning coffee. The reasons for failure are different from the model purchased unsuccessfully to poor care unit. You can correct most problems yourself. If the control unit has broken or burned fee, can not do without the service center services.
The simpler mechanism, the less the fault in it can be. Repair drip coffee makers is flushing the filter screen from the accumulated oils. When using tap water pipe clogged with scale. Enough to buy a special tool and instructions on its packaging wash drainage system. It is not necessary to save and replace the special composition of vinegar. Will soon have to change pads that will corrode it.
When the drip coffee maker has ceased to heat, it is necessary to check the wire and connectors. If they are OK, then blown heater. His replacement will be more expensive to buy a new coffee machine of the same type.
Most of the problems associated with coffee makers capsule coffee tablets:
- incorrectly inserted;
- Capsules another company;
- poorly pressed a lever.
You have to buy a tablet is only one brand that coffee and gently toss them a piercing mechanism and rather sharply to press the lever. If this does not work, disassemble and clean the mechanism.
We carob models often broken seal. Water starts to drip out of the horn. The reason for the contamination of the sealing ring, or its destruction. Ring rinse. If it is cracked, replace it. You can not put automotive gaskets, and a washing machine. They tire has a different structure, it is toxic for food.
Leakage from under the horn DeLonghi Coffee maker is more common than others. No need to rush to the service center, repair of coffee machines Delonghi model with his hands is quite simple. A detailed description of the schemes have the data sheet on the car.
Each model has its weaknesses. Clogged filter becomes more often the cause of failures in the machine "Saeco Minuto", "Roventa", "Nescafe Dolce Gusto", "Krups».
Change the high-pressure pump is often necessary to have coffee makers range Vitek. Coffee starts to run low, bad brew.
Coffee machine "Saeco", "Delong", "Philips" have a complex electronic system and the drive is sensitive to voltage fluctuations. They are installed inside the disposable fuses against overloads. When the power-line surges protection trips, and they will no longer run. Dismantling and replacing fuses coffee machines Saeco Minuto own hands possible in the presence of spare parts and knowledge of electrical engineering.
The main causes of damage to coffee machines of all types of the same:
- clogged filters;
- Use of raw water from the tap;
- power surges;
- neglect to the equipment;
- no regular cleaning;
- wear parts for long term use.
If the coffee machine broke down, it is necessary to disassemble, wash and clean, check the integrity of seals and components. After that, in most cases, the machine starts to work.
should analyze the type of failure before repair, and the ability to self-help in the "Dolce" devices, "Delong" and others.
Saeco coffee machines for repair should be aware that their body can not be disassembled. The lid is secured by several screws. First you have to remove it, and then from the top to dismantle the teapot and other components. Making it inconvenient, it is necessary to lay a screwdriver and various stops.
Is no water
The main reason - the filter is clogged or has formed an air pocket. If the pump is running and water is not flowing, try to fix yourself. You need:
- Open water cap. Gently pull out the filter. On some models it is necessary to push back the release latch.
- Clean the filter.
- Turn its inlet tube and the lead-up. The filter is completely filled with water.
- Fill the tank and replace the filter in the water.
It does not work kapuchinator
Pena has become weak or even instead of it in a cup of hot milk is poured. The reasons for failure are simple:
- milk quality does not match;
- bad care - clogged pipe.
Milk should be taken only pasteurized with a fat content of 2.5% to 3.5%. You can not pour milk powder and just boiling fat. After each tube and frother kapuchinator be rinsed under warm running water for about 3 minutes, so that full fat washed.
Grinds coffee grinder is not
Remove the grinder and check delivery grains in the grinding compartment. It funnel clean, and adjust the freeness. Very small and large coffee can score a millstone. From the oil contained in the grains, formed plaque, preventing the passage of powder.
If after cleaning the grain does not fall into the grinding department, need expert help.
Leaking or leaking coffee machine
Water flows out of the horn, accumulates under the coffee machine, check the O-rings. Often under them milled coffee hits, grease and dirt. It keeps leaking and steam comes out. On DeLonghi models in the instructions of buyers pay attention to the careful attitude to the coffee machine. They have water collects in the tray and below the machine.
It is necessary to open the case, remove COFFEE unit and check the O-ring. Remove it, rinse and clean the entire unit and set in place. In case of formation of cracks in the ring, you have to buy a new one. To do this in a specialty store should take your passport. Rings with other manufacturers of equipment will not fit. They will be rougher or smoother, other sizes.
horn filter should be flushed. If it is clogged, the steam coming under great pressure, finds an outlet in a weak place. By analogy checked the infuser in the coffee machine, cleaned all the tubes.
Leaks should be eliminated in time. Inside the car a lot elekticheskogo equipment. In contact with water it may happen on the closure body and the electric shock. In the best case, the engine will burn or the board.
It does not turn the device
Check out all of the outlet to the power button. To do this, use a screwdriver and a display multimeter. Broken and dirty contacts need to be cleaned. At low voltages the equipment will not work.
If the coffee maker before that worked and turned off, check the heat shield.
Pours coffee
Coffee flows trickle or dripping at all, should start with the washing and cleaning of the tubes and parts of salt, fat and dirt. The machine hisses steam escapes to the outside and does not flow into the brewing unit, it is necessary to conduct decalcification - descaling. To do this, use a special composition. In an extreme case, the citric acid solution, and thereafter well washed. Vinegar can not be washed.
It is necessary to clean all components of the coffee dust, oil and dirt. If the problem persists after this, contact the service center.
Flashing light or an error on the display
The display ciphers are displayed various breakdowns. Their designation is available in the instruction manual. There's also pointed out how to fix the equipment with his own hands.
If breakage issued display does not exist, it is necessary to check the water level sensors, heat and pressure. the display control unit outputs a signal based on the sensor readings, starting and ending with a float arranged in the container.
Noise within the device during operation
Appears extraneous noise inside the coffee machine during its operation, thus deteriorating the quality of the beverage, filling the cup to half, there are other problems - must flush the system. Make it better with the use of special means for cleaning coffee machines.
It is necessary to remove all the blocks, wash filters, coffee grinder, the steam supply tube. You should check the bin for recycling meal, pay attention to the fixation strength of different nodes, the presence of foreign objects.
A speck of dust can be removed with a toothpick. Use a metal tool can not. He will scratch the surface smooth, and clogging of the ground coffee will occur more often.
The filter may be clogged due to the very finely ground coffee. Dust enters the cells and clogs them. It is necessary to manually adjust the grinder, increasing the size fraction of ground grains.
When much noise machine does not work even after cleaning - wear it to a service center, even by specialists.
Not hot water
Warm water heater disposed at the bottom of the coffee machine. If the water is not heated and no vapor is formed, the heating element should be checked with a multimeter.
TAN refers to expensive parts. In simple coffee machines and the cost of replacement services can be equal to the price of the new unit.
Panel with buttons not working
Button is pressed and there is no reaction. Need to check:
- the presence of water in the tank;
- button, clean or covered with coffee;
- is there a grain in the container;
- Plug in the appliance;
- no kinks wires.
When checking the wires and plugs, the machine must be disconnected from the power supply. In the presence of the meter and the ability to use it should ping contacts on all buttons. Buttons themselves before this wash alcohol with a cotton swab. If they were covered with coffee or something else, they can get stuck.
Having done everything possible and not correcting unit, it is necessary to call the professionals.
The device does not see the coffee
Coffee is poured into the container, and the machine does not see it. The reasons for the failure of a few:
- the internal mechanism of a coffee filled with dust from the broken kofevoda;
- coffee hit the engine compartment;
- clogged funnel kofevoda;
- the control unit has broken.
Start repair should be with the cleaning of all components, funnel kofevoda grinders. If the coffee hit the engine, it should be changed. Look around, maybe cheaper to buy a new unit. The control unit is replaced in the service center.
Carefully analyze the reasons for failure, washing and brushing machine, coffee maker, in most cases you can repair their own hands. The main reason for failures - improper care and neglect. It is necessary to read these instructions and comply with its requirements.
