When it comes to device Russian bath, Everything revolves around the humidity and temperature. At the same time on the air exchange unjustly overlooked, and because it is the first two conditions depend on it. Stagnant hot and stuffy atmosphere spoil all the fun of bath procedures and make them dangerous to health. Today in this review HouseShief.ru we discuss what should be the organization of proper ventilation in the steam room bath.
Read article
- 1 The importance of good air
- 2 Types of ventilation in the steam room
- 3 The locations of the ventilation holes in the steam room
- 4 Four basic rules of organization ventilation in the steam room
The importance of good air
Before talking about the technological aspects of venting steam, let's understand the question of its necessity. Only people who are far from understanding the correct arrangement bathMay be considered unimportant ventilation and optional torque. This approach is fraught with many troubles:
- life of the entire structure is significantly reduced due to the aggressive influence of the hot humid atmosphere. After some 5 years steam casing will need to be completely replaced;
- stagnant atmosphere without proper ventilation accumulates a lot of carbon dioxide and carbon monoxide, which can cause irreparable damage to human health;
- lack of fresh air leads to the concentration of odors in a wet steam room, from which it is practically impossible to get rid of later.
Types of ventilation in the steam room
ventilation system in the sauna can be done in three ways: mechanical, natural or combine them.
Natural ventilation involves the exchange of air flows from the street due to the pressure difference. Organize it is very simple: the ventilation hole is located under the ceiling. Hot air tends to strive upward, and so he leaves the steam room, and a rarefied atmosphere of air pulls itself from the street through supply valve. Special costs for such a system is not required, and all would be good, but there is one "but." With this air exchange heat in the present the bathhouse will not work.
The mechanical method involves installation fanWhich are controlled devices that respond to temperature and humidity sensors. This forced ventilation is more effective to mount holes can be anywhere in the steam room. The only condition - the fans must be made of heat-resistant materials, because the steam temperature can reach up to + 130ºC.
The combination of these two types of ventilation systems provides for the installation of the fan on the exhaust and simple supply valve for fresh air intake.
The locations of the ventilation holes in the steam room
There are several successful working air vents layouts that can be used in the steam room. Supply valve can be installed in oven 50 inches from the floor, and mechanical drawing - in front of the floor. With this arrangement the cold air is rapidly heated in the bath is maintained high temperature. Options for the location of ventilation holes:
As you can see, if any of these options, the incoming flow will be well warmed up.
Four basic rules of organization ventilation in the steam room
You can choose any of the proposed schemes, but there are some rules that are the same for all variants.
- Ventilation passages should be installed during the construction of walls, because then punching them in the thickness of the wall, the occupation is very time consuming. That is why the scheme of arrangement air ducts better define the time bath design.
- The diameter of the supply holes should correspond to the size drawing, the only way to establish full outflow of the exhaust air.
If you want to make the process more intensively - the hood can be made bigger or immediately install two - All air ducts must be equipped with valves. With their help, you can adjust the airflow and easy flushing steam room, without spending too much fuel. Closed ventilation flooded. We began to bathe - parted finished bath procedures - open for full ventilation.
Adjusting the inlet air stream favorably influence the velocity warm bath - Diameter air duct It must match the dimensions of the room. On 1 m³ laid 24 cm section.
In conclusion, we offer you a small, but informative video on the subject:
Remember that a good bath It should smell birch brooms and eucalyptus, and not musty dampness. So do not neglect high-quality ventilation.
If you have more tips on this subject - write in the comments
