How to wash a bath of plaque and yellowing at home: effective tools and methods

Surely every good housewife wondering how to clean a bath at home. Shop tools often can not cope with difficult dirt and grime coating. There is no need to throw your money away by buying such funds. From the most complex problems will relieve people's money, time-tested.

Prichny appearance raid

Gray spots, yellowing, rusty streaks - all this greatly spoils the appearance of the once snow-white bath. Whence do these troubles?

• Yellowness. If you do not wash your plumbing for a long time to wash or store chemicals on it formed a yellow plaque. This is due to the water - usually it flows through the old pipes rusted, because of what is formed and yellowness.
• The appearance of lime deposits associated with prolonged contact of hard water with enamel. Gray deposits not decorate the appearance of any plumbing, and clean it hard enough.
• Rust is perhaps the most stubborn problem. It is usually formed around drain hole due to oxidation reactions.
• Average plaque consists of soap, shampoo, which we use, and dead skin particles. Such a plaque is easily washed off with water and sponge.

Shoe enamel

Covered by enamel bath, made of steel or cast iron. Over time, the enamel is erased, it microcracks, which settles and dirt. Therefore it is impossible to use the hard brushes, scrapers, and metal sponges for cleaning such baths.

Here are some of the popular methods, time-tested. The main means of all prescriptions are soda, vinegar, Ammonia, Soap, citric acid.

These products are in almost every home that allows you to quickly clean up the old cast iron or steel bath tub without chemistry.

Vinegar and soda

Soda is used for cleaning literally everything in the house. It perfectly absorbs any contamination, yellowness and plaque - not the exception, but on condition that the raid on the chronic. If from contamination can not get rid of for a long time, soda and vinegar can help in this. This cleaning is carried out in two stages. First you need to wet the surface of the bath and sprinkle it with baking soda. Particular attention should be paid to places of accumulation of dirt.

After 15-20 minutes soda layer apply vinegar or acetic acid. For a more uniform distribution of the funds is better to do so: to cover the entire tub paper towels or toilet paper and moisten it with vinegar.

The paper absorbs the vinegar, and it is uniformly distributed over the surface being cleaned. Leave the plumbing in this state need 40-60 minutes, Then remove the paper and flush the plumbing warm water and a sponge.

Vinegar can also be used as a standalone tool. Dial into the bath water, add to it a couple of tablespoons of vinegar and leave overnight. Means morning wash with clean water.

The disadvantage of these methods - a strong smell of vinegar that carry throughout the apartment. Therefore, if one of these cleaning methods has been selected, for the duration of the treatment is necessary to open the bathroom door and window in the house.

• Soda and ammonia. You need to cook gruel: the required amount of baking soda diluted with sal ammoniac. Sponge or cloth applied on the enameled surface of the solution and left for 10-60 minutes (depending on the severity of contamination). Rinse with clean water.
• Soda and bleach. To clean the old cast iron bath can safely use powders. Any abrasive substances: citric acid, soda, washing powder. A very effective means of - a mixture of soda and powdered bleach. Mix them in equal proportions necessary and treat contaminated surface.

And liquid soap

Stir soda and soap in a proportion of 1: 1. Wash plumbing resulting slurry, pay special attention to spots and streaks. Rinse with clean water.

If desired, one can add a solution of antibacterial oil. In this case, rinse well with a bath, not to accidentally slip.

You can also grate half piece of soap and dissolve it in a small amount of warm water. Pour into a soap solution of liquid ammonia teaspoonful and put it on the enamel surface. After 15-20 minutes rinse with water. Pollution should be easily removed with a soft cloth.

Lemon and citric acid

If not strong contamination you can use half a lemon. We need to take a lemon, cut it in half. One half of the fruit rub the surface of the bath, and wait 15 minutes, then rinse. Lemon is not only clean fresh plaque, but will bleach the surface.

Another embodiment - Dissolve sachet of citric acid in a water glass and wipe with a spongeDipped in a solution bath. Leave on for half an hour, then rinse. If necessary, repeat the procedure.

Funds from rust

When applying means it is desired to slightly rub their surface. Regardless of what is selected for cleaning sanitary ware, be sure to do it with rubber gloves, not to accidentally burn the skin of hands. Vinegar, alcohol, chemical substances are very harmful to the skin.

Here are a few home remedies for getting rid of the rust. They are used all the same: applied to the bath with a soft spongeAfter 30 minutes, washed with water:

• hydrogen peroxide and ammonia in the proportions 1: 2;
• heated vinegar and salt added to it;
• slurry of salt and turpentine.

cleansing acrylic

Acrylic bathtubs are good because they do not accumulate plaque, they do not turn yellow and almost no contamination. They must wash no more than twice a week. Instead of washing you can disinfect the acrylic bowls a special tool.

There are two types of acrylic baths: light alloy and coated with an acrylic. Spray erased with time, or when using aggressive detergents. Therefore, choosing the material for his acrylic sanitary ware, you should prefer the cast coating, in spite of the appreciable difference in the price.

The first rule cleaning acrylic bathtubs: abrasive particles can not be used. Such exceptionally clean sanitary gels, liquid soap, any soft material. You can even use dishwashing detergent - put it on the surface to be cleaned and wash off after 10 minutes.

Whitening acrylic sanitary ware can be used citric acid, Dissolved in water.

Caring for marble

Marble bath - a luxury item. Few can afford such a subject plumbing. When washing bath of stone observe the following:

1. Marble not wash chemical means.
2. When cleaning using soapy water or water with ammonia.
3. To this long served as the plumbing, it must be regularly restored. In this case it is better to resort to professional help.
4. White marble bath can be bleached using lemon juice and salt.

Tips and tricks

The problem is easier to prevent than to solve it. Here are a few tips for the bath care products that allow to enjoy the whiteness of their plumbing every day.

1. The bath should be rinsed after each use. Optionally, do it with detergent, simply rinse the surface with water and wipe with a sponge.
2. After each use, you need not only to rinse the bath, but also to wipe it dry. The Council, which is rarely used hostess. But precisely because he will be able to forget exactly what limescale deposits and yellowness bathroom.
3. The enamel disintegrates under the action of high temperatures (above 70 degrees), therefore it is necessary to observe the temperature regime unless plumbing coating is not stable to temperature.
4. We must take into account the material of construction of the plumbing, and not to apply the cleaning agent, not intended for the selected coating. For example, acrylic bathroom fixtures can not be cleaned with abrasive agents, and the old cast iron - bleached using acids.
5. If washed hair dye in the bathroom or other dyes after the procedure it is necessary to wash it with detergent. Paint good eats into the enamel.
6. It is not necessary to use chemicals for cleaning sanitary ware more than once a week.

You can clean the bath at home with the use of the cheapest funds due to them not one mistress is no longer upset the form of dirty bath. BUT subject to the care tips for plumbing use these funds do not have to do.