How to assemble a chandelier with pendants and a console?

Recently the market is literally flooded with ceiling lights with a remote control. In addition to turning on and off the lighting, there are additional "bells and whistles", such as: brightness control, changing the color of LEDs as desired, music effects, on-off timer. As for design, it can be almost anything - from pretentious to strict "high-tech".Today, let's talk about how to assemble the chandelier with the viscose and remote control.

to the contents ↑

Installation algorithm

It is the same as installing the most ordinary ceiling light:

1. When buying the device, be sure to check its completeness. Do not forget the detailed step-by-step installation instructions. Do not be lazy to check the serviceability of the lamp.
2. Before assembling the Chinese chandelier, find a set with holes and nuts with bolts. This set is necessary in order to make the basis for the installation of the chandelier.
3. The next step is the marking of points for drilling in the ceiling slab.

Important! You must be especially careful not to touch the wiring. For gypsum boards use Molly bolts.

to the table of contents ↑

Assembling a chandelier with chunks - connecting to the electrical network

Before starting work, be sure to disconnect the machine in the shield, thus de-energizing the line. Now it's time to tackle the wires that come out of the ceiling:

1. Carefully straighten them and level them to fit.
2. The ends of the wires must be stripped to 15 mm.
3. If the wires are painted in the same color, you need to determine the phase.
4. Split the wires to the sides, turn on the machine and find the phase.
5. Mark the phase wires with a marker.
6. Then turn off the machine again.

Before connecting the chandelier with the remote control to the double switch, carefully consider it. The upper bowl of the luminaire is equipped with a plastic terminal for connecting the cores and a control unit. To the terminal, three kinds of wires are painted, painted in different colors:

• N - black or blue - corresponds to zero.
• L - brown or red - corresponds to the phase.
• PE - yellow-green. This terminal is not used in houses with old type wiring.

It is advisable to mount the lighting fixture together with the assistant who will hold the fixture while you make connections to the terminals. If there is no assistant, you can hang the appliance on a temporary wire hook or rope. The ends must be insulated.

to the contents ↑

Finishing straight

So, how to assemble the Chinese chandelier with the viscose and remote control, figured out. Now it is left, following the instructions, to collect all the elements, to mount the lampshade and lamps. Pay special attention to the contact between the cap and the lamp. After all installation work is completed, turn on the machine, thus feeding power to the lighting line. Then try to "play" with the remote, switching it to different modes.

Important! The luminaire will function only when the switch is in the on position( this will energize the device, only in this case you can use the remote control.)

As you can see, everything is not so difficult, However, if your knowledge of electrical engineering is limited to a half-forgotten physics course for 9class, call the master. You do not need injuries.