How to clean the sink from the blockage at home?

Probably, there is no such mistress who has never encountered problems associated with home plumbing. Small particles of different origin, falling into the drain hole, form clogs. Even the most accurate mistress is not immune from such trouble. Gradually, clogs accumulate in the drain pipe and reduce its permeability. The most problematic in this respect is the curved section of the pipe, or the hydraulic seal. If the shell is still clogged, it is not necessary to call for plumbing. From this article you will learn how to clean the sink from blockage at home by yourself. The methods set forth in the material have been tested by many people who have experienced all the "delights" of sanitary engineering surprises.

to the contents ↑

Hammock

This is the easiest way to eliminate the clogging of the shell. It consists of a tool made of a rubber hood, mounted on a handle. The principle of operation of the air vent is based on the creation of a hydraulic shock. Under the impact of a hydraulic shock, the waste that is stuck in the drain pipe moves towards the sewer pipe.

How to use:

1. Fill the sink with water so that the rubber part of the device is covered.
2. Attach the hood firmly to the drain hole and make a few sharp forward strokes in the direction from top to bottom. As a rule, 3-5 shocks are enough to restore the passability of the drain pipe.
3. If the water still does not go away or goes too slowly, then the procedure is repeated until a visible result is achieved.
4. Dirt that emerged from the sink must be cleaned immediately so that the sink is not clogged again.

Important! If an old sewer system with rough cast-iron pipes is used in the house, you may have to try again several times. Sometimes the first try is ineffective.

to content ↑

Several folk recipes, or how to eliminate clogging in the sink with soda

All these methods are time-tested, but they are based on the property of soda to dissolve the fat in the clogging, thereby reducing its volume and density.

So, here are these recipes, how to clean the sink from the blockage at home:

• Pour 3 tablespoons of baking soda into the sink, and then pour a large amount of hot water.
• Pour 3 tablespoons of soda with one glass of 9% vinegar. Pour the mixture into the sink, then pour it with hot water. In this case, a chemical reaction will occur with the dissolution of the fat component of the garbage "plug".Thus, the pipe will again become passable.
• Fill the sink with an equal amount of soda and detergent, then pour vinegar into the drain hole. Wait for 20-30 minutes until a chemical reaction occurs, then rinse the mixture with hot water.

Important! Soda and vinegar are often used in cleaning kitchen sinks, since it is in the kitchen sink that the accumulations of fat that are to be dissolved are most often formed.

• Here is another good preventive tool. Prepare a formulation containing 1 part of citric acid and 2 parts of soda and salt. Pour the mixture into the sink, add two parts of boiling water. Flush the product with water after 5 minutes. Prophylaxis once a week.

Important! Recipes how to clear the litter in the sink in the kitchen at home with soda and salt, are good for putting the kitchen. If you need to clean the drainage of the bathtub or bathroom sink, it is best to use a mechanical method.

to the table of contents ↑

Household chemical goods

Along with folk remedies, special means are used to clean up blockages, which are sold in household chemical shops. Use these drugs is not difficult. It is enough to fill the sink drain with the prescribed amount of the equipment, and after a certain( again instruction!) Time to wash it off with water. This leads to dissolution and rapid elimination of the clogging.

to the contents ↑

Mechanical cleaning

Of course, it is not pleasant to call this manipulation, but in order to effectively clean the pipes while maintaining their integrity, the mechanical method is fully justified. How to clean the sink in the sink at home?

PVC siphon

Under the sink is a siphon, which serves as a kind of sedimentation tank for sedimentation of contaminants. This prevents the ingress of contaminants inside the pipe, which can make cleaning quite difficult. If the siphon is made of plastic, then it must be cleaned and disassembled, releasing water from the sink first.

Important! After cleaning the siphon, it is necessary to check if the corrugated pipe is dirty. After that, the siphon is again twisted

Cast iron siphon

If the siphon is cast iron, then cleaning it is somewhat more difficult. This is a non-separable structure, which in case of contamination needs to be cleaned with a special cable and rinsed. After all these manipulations, you can set the siphon back.

If you do not want to disassemble the siphon

You can use a special plumbing cable to clean the sink drain, without examining the siphon, which is inserted into the drain and turns in different directions. The drain is cleaned sufficiently qualitatively and reliably.

The procedure is as follows:

1. Insert the end of the cable with the drill into the drain hole. With the help of a drill, direct the cable to the intended site of the blockage.
2. Push the cable through the pipe, while simultaneously turning around its axis. It is desirable to do this manipulation with an assistant. Working alone is not entirely convenient.
3. Holding the cable tight, push it through the pipe.
4. When in contact with the plug, scroll the cable first to one, and then - the reverse side. Alternately, push the plumbing cable forward and pull back.

If your attempts were unsuccessful, the most reasonable solution would be to call the plumber from the housing office.

to the contents ↑

Application of the hydraulic pump

With the help of a conventional hydraulic pump it is possible to create a strong water flow directed towards the sewage drain. If the clogs "sit" too tightly and wash it off with a stream of water does not work, then you can try to displace the "cork" by acting as a suction.

The algorithm is as follows:

1. Dampen a piece of cloth with water.
2. Cover the overflow hole with a cloth.
3. Put water in the pump.
4. Press the wort of the pump against the drain hole.
5. Pump the pump by discharging water into the pipe and sucking it again.

to content ↑

Prophylaxis of

Everyone knows the proverb that the disease is easier to prevent than treat. The above preventive measures will allow for a long time to avoid littering of the sink and the questions of how to clean the sink from clogging:

1. Regularly clean the siphon from food and grease residues. After each dishwashing, it is enough for half a minute to leave the hot water on.
2. Sewer pipes are well rinsed with hot water. After the pipes are rinsed, you need to work with a plunger.
3. Use special grids on the plums. If you do not pour the remains of coffee and tea leaves into the sink, there will be no problems.

Now you know how to eliminate clogging in the sink at home by yourself. Applying simple preventive measures, you can avoid clogging the pipes for a long time.