Why batteries heat up unevenly: causes and solutions

The problem with uneven heating of the batteries is now faced by many. And the colder it is outside, the more acute this issue will be, because the comfortable temperature in the apartment and house will depend on how the radiators heat up. Moreover, it does not depend on the material from which the batteries are made. Is there any way to deal with this? It is possible and necessary. Let's discuss the causes of such problems and how to fix them.

Read in the article

  • 1 Got air
  • 2 Foreign body in the system
  • 3 Failure in the locking system
  • 4 Low system pressure

Got air

This is the most common cause of uneven heating of radiators. An air plug has entered the heating system, and it is this that prevents the normal movement of the coolant.

In modern radiators there is a so-called Mayevsky crane. This is a valve for bleeding excess air. Just a couple of minutes - and the problem is solved.

Why do batteries heat up unevenly?
PHOTO: akvahit.ru
It is necessary to turn off the water supply valve, leaving the return valve open, and bleed the air through the Mayevsky valve

Well, if you still have Soviet-style batteries, then you can’t do without the help of public utilities - you have to drive the cork through the entire riser.

In private homes, the problem is solved by pumping coolant through the drain cock at the bottom of the system. Back pressure will force the plug out.

Foreign body in the system

The cause of uneven heating of the radiator may be sediment or a foreign body that has clogged the system. Scale inside old batteries under pressure can separate and clog narrow coolant ducts.

If the water is too hard, lime and salt deposits can form inside
PHOTO: odstroy.ru
If the water is too hard, lime and salt deposits can form inside

In the end, debris can enter the system from the outside, if the system is not centralized, but receives replenishment from open hydraulic tanks.

Dirt can accumulate in any place that is difficult for the coolant to pass through, and usually these are radiators. There are two working ways to clean up junk from batteries. The first is a simple mechanical cleaning, in which the battery is turned off, the water is drained from it, and tapped with a rubber mallet to separate debris. After this procedure, the radiator is washed with a good pressure of water and put in place.

The second option is the use of cleaning compounds. It can be any remedy for blockages. It is poured with hot water and left in a disconnected battery for half an hour, after which it is washed.

If it was not possible to cope with the blockage on their own, the masters who use special pneumatic equipment for such work will help.PHOTO: ufa-santehnik.ru
If it was not possible to cope with the blockage on their own, the masters who use special pneumatic equipment for such work will help.

Failure in the locking system

On modern batteries, ball valves with thermal heads are installed to adjust the heating. They can also cause uneven heating.

To correct the situation, it is enough to simply replace the part that has stopped working. Ball valves and spare parts are sold in specialized storesPHOTO: m.kolorit.ru
To correct the situation, it is enough to simply replace the part that has stopped working. Ball valves and spare parts are sold in specialized stores

Low system pressure

The temperature difference between the top and bottom of the radiator may be due to insufficient pressure in the system. This often affects old-style apartment buildings. The batteries there are cast iron, with passages half-overgrown with scale.

More powerful pumps are required to ensure normal circulation, and their installation depends on the management companyPHOTO: belgji.ru
More powerful pumps are required to ensure normal circulation, and their installation depends on the management company

A drop in pressure can occur if your neighbors have unauthorizedly increased the number of their batteries or adjusted them so that the equipment simply does not do its job.

Solving this problem alone will not work. You need to contact the management company and bring to them not only your problems, but also assumptions about the reasons. There is no time for friendship with neighbors - your own shirt, as they say, is closer to the body.

In addition to the above reasons, you may encounter a trite incorrect installation of the entire system - usually such problems are detected immediately after startup.

And some more useful information on this topic - in the video:

Have you encountered such a problem? Share your experience of solving it in the comments!

Discuss0

Hello, my name is Andrey. I am buying information sites. There is…

and if the top layer of foam is not broken, then the lacquer surface greatly reduces the hygroscopic ...

strange reasoning regarding sealing. If the log is doused with sealant, foam ...

In the 80s he worked in one NPO, then hammer enamel was sintered. It turned out great,...

While in the summer I lived in the country a lot of different situations I saw and no one fines anyone. Uch…

You won't find a normal apartment for such a sum in Moscow. Even for a country house that …

Thank you. Briefly and clearly...

Karting. I want to help children! &nbs …

Now there is a very interesting and effective option for heating - plasterboard pas …

Everything is chic, but the emphasis is always on the ratchet. And for me, for example, it is technologically not p ...

yes indeed. you won’t call them later for the whole year no one appeared, they began to hear ...

And why sheathe the house initially with vapor barrier? What is its meaning? To create a conden…