How to properly adjust the brushcutter so that your back and arms do not hurt

The gas cutter is, without a doubt, a more productive tool for work than a conventional manual one. In addition, brushcutters are now sold with an electric drive. It is not very convenient to be tied with a cord, but even this option is better than a manual one. There is only one problem - both petrol and electric scythes weigh five times more than their manual counterparts, and in the process of work, the back and arms receive a great load from both weight and vibration. So the operator in this case is still tired, and it is difficult to work with such a weight for a long time. But in fact, fatigue and muscle pain is not so much from the weight of the instrument, but from its incorrect position. If you adjust the braid, the load will be evenly distributed and it will be much easier for you.

The nuances of choosing a model

It is worth starting a conversation, perhaps, with the question of choosing a model. If you are on a budget and are looking for something cheaper, then keep in mind: cheap Chinese models very difficult to adjust, besides, they are made for the Chinese, that is, people of small growth. With our average height, you will miss both the length of the bar and the length of the handles.

PHOTO: bobrshop.by

The second important point is the equipment. And again, cheap models are losing: many of them do not have slanting belts, gloves or glasses in the set. Special belts can be bought separately, there are even special backpacks that are very conveniently adjustable for the owner.

How to adjust the fasteners on the brushcutter

Pay attention to where the hook is on the fastener when you put it on. It should be 15 cm below mid-thigh and horizontal. The scythe is suspended between the motor and the handles. Use a bar and loop for balancing.

PHOTO: sadovod.in.ua

The height of the spit landing also depends on your task. If you need to mow the lawn at a height as close as possible to the ground, you should lower the working part, if you need to cut off dense thickets, raise it.

Move your shoulders and assess the position of the straps. They should not bump into the shoulders or teleport freely.

PHOTO: avito.ru

To properly adjust the handles, try not to have to lift or press on them. They are only needed to turn the tool left and right, and the bar would move freely, and the handle would not hit the leg.

How to hold a brushcutter so that your back does not get tired

After balancing the tool, you can start mowing. Done correctly, you will greatly ease the strain on your back. But it is also important to work correctly.

The working coil must be parallel to the ground at the same height. There is no need to rush, you need to move very slowly, taking small steps. It is better to drive the barbell smoothly, without excessive swing.

PHOTO: faznik.ru

If your braid does not cope with tall grass in one pass, mow the tops first, then at the root.

Don't worry about keeping the revs at the same level. Fuel will be saved if you decelerate in reverse.

If you follow these simple guidelines, you will feel how the load on your back and arms will change. It will become much easier and your productivity will increase dramatically. And a few more simple recommendations - in this small video:

If you adjust everything correctly, it will be a pleasure to work with the petrol cutter. Which oblique do you use? Maybe you can recommend a model with a convenient adjustment? Write about it in the comments!