During his time stiralki it periodically break down the different parts. Most faults easy to correct yourself. For example, to change the bearing on the washing machine.
- Hammers usual and rubber;
- allen keys;
- Socket wrench set 12-19 grip;
- carob keys of the same size;
- wrench;
- Phillips and slotted screwdrivers;
- chisel with a broad area or vyboynik;
- lubricant for movable joints;
- new bearing and oil seal;
- insulating tape;
- sealant;
- a camera for capturing a phased dismantling, it will avoid problems with the assembly.
The order of execution of works
For a start, disconnect the unit from the mains. Disconnect hoses from the water pipes and sewage sludge. Allow sufficient space to work.
Dismantling of washing machines
- On the rear wall of the machine is two screws that are on top. Unscrew them and remove the top panel.
- Now you need to disconnect the feeder washing powder. Beneath it seems bolt, it must be unscrewed. After the need to remove the front panel of a washing machine. Under the panel will have two bolt to be unscrewed.
- Rubber sleeve on the hatch locks the pair of clamps. They must be removed, one by one. Then you need to pull off the very edge of the cuff with a hatch, making it very carefully so that it does not tear. Now it is necessary to press the device that provides the hatch lock.
Finally it was the turn of the front and rear panels. Each model has its own type of panel mounting. It is important to take pictures of each bolt.
Disconnecting PETN and water supply systems
- Remove the belt from the pulley.
- Disconnect the wires to the heating element.
- Disconnect connecting the tank and the pump.
- Remove the screws on the sides of the motor. Carefully pull the motor.
To disassemble the tank and bearing replacement:
- Remove the rubber sleeves and mark their position marker.
- Loosen screw on which is mounted a pulley and pull the pulley. Thereafter the shaft by hand drown inside the tank. If it does not turn by hand, use a rubber mallet.
Before you replace the bearing in the washing machine, check the hub shaft and the crossbar. If the device for a long time worked with broken bearings, components could be damaged:
- backlash in the shaft;
- crack on the crosspiece;
- breakage of the shaft to such an extent that the new gland will not hold water.
If there are no signs of these problems, it is easy enough to clean the dirt and scale shaft and sleeve. It is necessary to bring these items to the absolutely smooth state, and check for undetected plaque does not hurt.
It is time to remove the bearings from the drum of the washing machine dismantled. They need to knock out using a chisel and hammer. However, embossing should be careful, otherwise you may damage the tank.
If the gland, which also needs to be changed, not dropped, along with the bearing, to get it separately. Places to lubricate the bearing mounting. Now you can change the bearing on the washing machine, setting new with a hammer with a chisel. New packing must be liberally grease the same substance.
Gasket and treat the connecting seam sealant.
Guided imagery, collect the laundry appliance.
Perform a test washing to ensure correct assembly.
Nuances for different models
If the tank is molded, it is necessary to saw off that significantly complicate the task. The general trend today is this: the newer the car, the more likely that the tank in her molded.
Buying expensive washing machines can help to delay the wear parts. Quality affects only that, through a time period parts will fail.
you need to apply physical force to vpresovki bearings. You can try to change the bearings on their knees, then the probability of damage to the tank less. If new parts are pressed on the table, then it should be done very carefully.
Disassemble the washing machine - a difficult task. There is a risk of damage to the device or injure yourself. If not uvreny reliance, better contact to the master.
