Juicer for tomatoes: manual or electric

Most juicers can process almost all kinds of vegetables and fruits, making them drink with pulp or transparent nectar. However, not all of them are suitable for juicing tomato, this is due to the structure of these vegetables. Therefore we need a special squeezer for tomatoes.

In tomatoes tender juicy flesh, which a lot of moisture, so they can easily squeeze through any mechanism. But the structure has a lot of small grains, making it difficult to process them. Cope with the grinding of small hard seeds can not all juicers.

There is another nuance of tomato processing. Tomato juice should be thick with a high content of pulp. Tomatoes do not make the liquid nectar, like the apple. Therefore, the beverage ingredients should be well grind and mix into a homogeneous mass.

All juicers can be divided into three categories depending on the operating mechanism:

  • compaction;
  • screw type;
  • Centrifugal (rotor).

screw

The principle of operation is very similar to the work of the grinder. Products fall between the blades of the spiral shaft and the walls of the housing, are crushed to a pulp and pushed through metal mesh. Bagasse discharged into a separate compartment.

Electric screw type squeezer

In this method of processing is almost no waste, and in the finished beverage contains maximum of vitamins. This method is called cold-pressed. It is great for juicing tomato.

Good deal with tomatoes can only auger juicer, which crushes the powerful shaft products with any structure. These devices are equally easy to recycle pulp, peel and seeds. The output is a uniform dense drink, how all used to seeing the tomato juice.

small minus screw operation device may be called the processing time. The hand-held devices have to turn the knob, exerting physical effort. Electrical work at low speed, so the speed of the beverage preparation is small. However, this is not essential if you plan to get the juice in small amounts.

Into small portions designed compact auger juicer. They may be:

  • manual or electric;
  • vertical or horizontal stroke;
  • horizontal, in turn, are divided into single-screw and twin-screw.

Hand

More reminiscent of a meat grinder. It consists of a threaded shaft, a prisoner in the housing and the feed chute. Advantages of these models is that they are very compact and easy to maintain.

Auger juicer tomato may be made from metal or plastic housing. Now it produced many inexpensive models made of plastic. In tomato soft semiliquid structure, so the use of plastic material justified.

electrical

For pressing fruit here used motorWhich starts rotation of the shaft. Electrojuice do not require any physical effort from the user. It is enough to wash the vegetables, put them in the tray and press the power button. Electrical devices take up more space than a manual, but easier to work.

vertical stroke

screw design allows you to cut the fruit and tighten them inside, so there is not provided a pusher. Device with a vertical stroke smaller than the horizontal. They can be mechanical (lever) and electrical.

The mechanical model spinning takes place by pressure on a lever which press down and squeezes liquid from the fruit. In electric vertical shaft is rotated by a motor, which is located in the housing.

horizontal stroke

Here in the design provides the pusher, so pressing process is a little slower. Schematic horizontal auger type squeezer It can be equipped with a single shaft or two.

The second shaft is set to improve extraction. Usually, it has the reverse function, ie reverse. Due to the reciprocating motion of the two shafts spin rate increases, and the cake turns out dry.

For processing vegetables such as tomatoes are better suited devices with horizontal screws, as they effectively grind seeds.

If you do not plan to processing tomatoes in large numbers - will be quite small horizontal juicer manual type. With the help of easy to prepare a few glasses of tomato juice. If, however, from the large crop of tomatoes is necessary to prepare the drink liters - take the machine with electric drive. He will save both time and energy.

centrifugal

Here, the motor spins much faster, so you can quickly get the juice. But because of the design features make the tomato juice in the devices of this type is not recommended. Circular float, which crushes the products are well cut the flesh, but can not cope with seeds. Small fraction particles clog the mesh and it has to be constantly cleaned.

Electric centrifugal juicer

Inside the separator the liquid is separated from the soft part of the fetus, which goes to waste, making the drink obtained is very liquid and transparent. It is suitable for fruits such as apples or pears, but not for tomatoes. Therefore, the centrifugal device for the preparation of tomato juice is better not to apply.

pressing

There is another type of juicers - compaction, which are also suitable for juicing tomato. They are the fruits are crushed under the pressure of the press, acting on the fruit on top. Well with berries and fruits that contain seeds.

Hand-press juicer

Issue separate press for grapes or pomegranates. These mechanisms also produce beverages by cold pressing. Juice different density and high in vitamins.

Presses for the processing of tomatoes are suitable for a large number of vegetables. Tank capacity is several tens of liters. Such media are popular among gardeners, make good crops in their suburban areas.

Rated centrifuges for tomatoes

To facilitate the choice of models was made a little review devices for juicing tomato.

Dream Juicer Press JDP-01

Dream Juicer Press JDP-01

This is a manual press for cold pressing. Processes vegetables, fruit, large fruit. High performance - squeezes almost 99% of the liquid even from solid fruit. Durable metal stainless steel and simple construction.

Pros:

  • good recycles any fruit;
  • quickly press the juice.

Minuses:

  • cumbersome;
  • heavy.

VES 3005

VES 3005

Horizontal auger juicer with excellent performance. Presses about 80% of the beverage. Complete with a nozzle, which can be set in two positions for the fruits and vegetables of different sizes. The case is made of eco-friendly plastic.

Benefits:

  • easy to maintain;
  • berries for a comfortable funnel;
  • compact.

Disadvantages:

  • noisy in operation;
  • you need to pre-cut fruit.

Panasonic MJ-L500

Panasonic MJ-L500

Centrifugal model may operate in multiple speed modes. Of the additional options provided drip system and nozzle-blender. Copes with soft fruits, berries and herbs.

Advantages:

  • easy to disassemble and wash the body;
  • quickly press the juice;
  • It comes with a brush for cleaning.

Disadvantages:

  • the high price of about 11 thousand. rubles;
  • narrow neck.

Before purchasing a juicer for processing tomatoes, consider the views of other users. Check out their reviews and to take into account how much juice going to get.