💧 intricacies of epoxy resin: how to create and maintain the mixture weight prior to use

epoxy - a unique material for lovers of art and craft by hand. From it are obtained not only beautiful jewelry and jewelry, but also designer furnitureAnd interior decoration. But the difficulty lies in the fact that it is not sold as a finished product. By proper cooking depends on the quality of handicrafts. Editorial HouseChief produced several useful recommendations that will help in the work.

The first rule: the accuracy of proportions

Mixing ratio may vary depending on the brand and manufacturer. Prior to use, be sure to review the information. It does not rely on experience, any breach of the risk that the composition will have to be discarded.

Another rule - the exact observance of the proportions. On the eye to measure the components can not be. It is necessary to correlate the components by weight accurate weights. Second embodiment - to carry out measurements on the volume, e.g., using a separate syringe for each ingredient.

All components must be mixed in a clean container, but not the one in which we measured, so you can easily break the proportions.

The second rule: Compound Component

Careless and chaotic mixing of components will lead to premature solidification and disturbances of consistency. Massa can become viscous, and it will have to be discarded.

You need to properly perform the entire process of component connections.

1. The hardener is poured into the foundation, and not vice versa.
2. Stir need to immediately carefully and slowly for 3-5 minutes.
3. If air bubbles do not come out during mixing, you can remove them with a toothpick.

If the mass turned out too thick, it is worth just a little to warm it in a water bath.

The third rule: temperature control

It must be remembered that the epoxy resin reacts to the ambient temperature. In the polymerization process generates heat to 600 ° C, and its level is directly proportional to the mass of ES. Therefore it is impossible to put the mixture in a closed container, molds for pouring must be made of a refractory material.

Accelerate hardening process can be by means of temperature, it needs to heat the initial components, e.g., put on battery or next to it.

additional tips

Practical advice to help cope with the difficulties not only for beginners, but also improve the technology experienced craftsmen. For high-quality mass, use the following tips:

• water in any case should not fall into the mass, it will significantly reduce the quality of the product. For coloring only dry formulations can be used, which must be carefully knead;
• cooked weight should be used immediately within half an hour after its solidification excess balances will have to throw away;
• surface before applying epoksidki It should be degreased. If you need several layers, each subsequent applied to the uncured previous. Stickiness compositions provide better adhesion;
• is required to protect the epoxy layer by means of a dust cover or film;
• under the influence of sunlight resin can take on a yellowish tint. To prevent this effect must choose formulations containing UV-filter.

Related article:

Create jewelry, furniture, floor using a transparent epoxy resin for the fill.Epoxy resin - what it is, what can be done from an epoxy resin: interesting examples of what to buy a transparent epoxy resin to fill: popular brands.

conclusion

We need to work with the resin on a horizontal surface to avoid artifacts thickening occurred with only one hand. Over time you will learn how to properly knead the mass and unique things to do, more importantly, do not give up at the first failure.

Tell us in the comments, what tricks do you use when mixing the mass. What crafts have obtained the best?

Do not forget to "Like" and subscribe to our magazine, so as not to miss the most interesting reviews.

[Totalpoll id = »57458"]