Burnt pan: how to rescue and ambulance in the kitchen, the use of domestic resources and tricks

The appearance of burn-on dishes - a problem faced by many housewives. To return in a short time cooking utensils original appearance, you must immediately begin to purify it, and not to postpone the case until later. Ambulance in the kitchen from 7 Ways to save the burnt pots give the product luster and ransomed him from the black plaque and stains.

The use of salt and soda

This cleaning method is suitable for aluminum and enamelware. To save the capacity of a deposit, proceed as follows:

1. Mix equal amounts soda and salt.
2. Absorb the prepared mixture of baked-on surface and add a little warm water. It should get a paste.
3. Cover the container with a lid and wait a day.
4. After 24 hours, remove soda-salt mixture is added to the pan amount of warm water to the liquid plated burnt place.
5. Put the dishes on the stove and boil on low heat for half an hour.

It will only have to wait until the container to cool down, and then wash it. Washing should be made using a kitchen sponge and a liquid cleanser.

The following method can be used to purify fumes from aluminum and stainless steel cookware. For removal of contaminants within the container must pour soda handful to the bottom of the pan, wait 30 minutes and then baked-wash surface with a sponge and the cleanser. If the product is burnt on the outside, follow these steps:

1. Remove all plastic parts with dishes and place it in a capacious container.
2. Fill container with a solution of 5 liters of water and 500 g of soda. The liquid should completely cover the pan.
3. Then you need to boil the solution, reduce heat and simmer for another dish for 2 hours.
4. Turn off the heat, cool the liquid, remove the pan from the water.

It remains only to wash and clean the hard to reach places on the product in the usual way. After carrying out such procedures will be a pan like new.

Soak in vinegar and whey

For purification from enamelled metal penetration, aluminum pans and articles of stainless steel can be used serum. It is required to pour into the vessel 2 cm above the level of burnt place. After a day is necessary to drain the milk product and wash the dishes with the detergent. The serum contains a lot of acids, alkalis and chemicals that help to remove carbon deposits quickly.

A further embodiment is only suitable for cleaning dishes made of aluminum and stainless steel. In addition to removing fouling, the vinegar can clean metal from black spots. Burnt pan surface is required to fill 9% vinegar, cover the container lid and leave for 3 hours for exposure. After this time, you must thoroughly wash the dishes with a sponge and detergent. If desired, the vinegar can be replaced by citric acid or lemon juice.

Use of activated charcoal

This method is suitable for cleaning all types of dishes, perfectly eliminates the burning-off of milk and jam. 3 requires to take charcoal tablets, crush them into powder and fill them burnt bottom of the pot. After 40 minutes it is necessary to pour the cold water tank and left to stand for more containers an hour. After this it is necessary to wash the product in any detergent. Using this method, you get easily and accurately baked-wash surface.

Boiling in soapy

If the dishes are not heavily burnt, it is recommended to use this method of cleaning. It is easy to wash the pan can be due to the soap or liquid dish detergent. For this purpose it is necessary to fill the capacity of the hot water send to the soap chips or the washing solution to put the dishes on the stove and boiled at low heat for 20 minutes. Then drain the fluid a spatula scrape off the remaining deposits, and have embarked on the walls and bottom of the fumes rub hard sponge side.

special funds

Now on sale there are a lot of professional tools for the removal of metal penetration. Perform the procedure you need to wear rubber gloves. List of effective products:

1. Schoeman.
2. Oven Cleaner from Amway.
3. Chister.
4. Sparkling Kazan.
5. Giant.

Means you need to treat the problem areas inside and outside of the dishes, Place the pan in a bag or wrap in plastic wrapAnd then leave to act 10-40 minutes. The exact time specified in the instructions for the product. Then wash the required capacity of the detergent and rinse several times with clean water.

Thus there are many ways that can remove metal penetration to the pan. Taking advantage of any of them, you can easily and quickly return the product to the original appearance.