Quite often it happens that bought the clothes do not correspond to the growth of the host, and it has to be shortened slightly.
This is especially true with pants, jeans, for example.
There are the easiest way to hem jeans while preserving the factory seam - it does not require a lot of effort and time, and the result will be perfect.
Of course, you can simply tuck the legs, but it will have to do every time.
Therefore easier to hem jeans:
- Wear jeans and dress shoes, with which they will be worn often. Bend the article of clothing, to to the floor surface remains approximately 10-15 mm. Stab needles intended site.
- Several times to walk around the room and sit down. Pants during these manipulations bit will rise up, so you have to drop a little more length.
- Remove the jeans, trousers and turn half tuck. Measure the distance from the bottom is necessary to factory hem. This should be done across the lines podvortyvaniya.
- Pin intended length of needles across the machine stitching.
- Stitch the product on a typewriter. You must make a line along the edge of the hem of the factory.
- If there is any doubt about the length, you can re-try the product. If everything is in order, it is measured about 15 millimeters from the made weld, and cut off his pants.
When cropping cut stitched side seams. After all the manipulations they should be as straight as possible to join. Otherwise, you will notice that the seam cut. If the defect is seen, the line is necessary to rip and re-align the edges.
To inseam thread climbs, Worth going over jeans overlocking. After that you need to turn leg and lay a line along the edge of the seam is not pushed down. The thread should be possible to match the shade of the product.
On the front side to the side seams needed to make tack 1 cm. Thanks to them, the seam will not be bent. After that, the product is ready to wear.
