Incisions can be placed longitudinally, transversely, or just be round. cut length depends on the size of the buttons. The loop is not deformed, its size is made smaller buttons. Buttoned button should not go for the bar, this is not a transverse hole in the middle and a bit is shifted to an opposite edge. Longitudinal sections vyvyazyvayut middle. Transverse buttonholes carried out in two ways.
Method 1. Chart on bladed middle band. Now make transverse hole by moving it to the left relative to the central loop line. To do this, in the beginning of the series, followed by the edge loop knit loops to cut, then close the cut loop, to the end of a series continue knitting in the usual manner. When knitting of the back of a number of closed loops to throw a spoke several loops. Their number should be equal to the number fixed.
Subsequently, a number of them are performed in garter stitch for the bobbin thread, then the cut will not be stretched.
Method 2. Armhole for a loop is made in the same line and it turns out narrower than the previous sample. First, remove the first loop and provyazyvayut several loops. to cut the loop without fixed working yarn threading them into each other in turn. Labor thread is located at the beginning of the slot. To end the knitting, dial the needle thread work the same amount of air loops way, as has been fixed. Until the end of the line to continue knitting in the usual way. In the following series of loops knit garter stitch cut for the lower thread.
Longitudinal slits may also be performed in one of two embodiments, wherein the armhole to the loop located in the middle plate.
method 1. The right half of knit strips and remove the pin, and the rest of the loops knit to the height of the proposed incision. Thread preserve near the holes. Loop, located on the pin, translate into extra needle and put in place a second ball. Vyvyazat thread with a secondary coil at least 2 rows, than the main thread holds, second strand break. Combine knitting, knit the entire line of working thread trims. Thus it is obtained a longitudinal bore.
method 2. Hinges right lobe knit strips and remove the needle-added. The left half of the knit for a number of rows. Then work to make a few turns of thread on the right needle. The number of turns equal to the number of rows of the section height. After this, knit loops with extra spokes to the whole strip was on one spoke. Next, fit the right lobe strap: provyazat range up to the incision site, and with a final loop knit one turn.
Work to turn, start to remove the loop, not provyazyvaya, and the finish line. So to continue to reduce all the turns.
Make a round hole is simple: where there should be a hole made sc, sc is thrown off from the spokes, not provyazyvaya in the subsequent row. Or on the reverse side of the product is sc, and the next two loops knit together. Next knit sc front loop.
For knitting patterns you can make your own buttons. To do this, you need to link the small squares and obtyanut of conventional buttons.