It happens that immediately begin to squeeze out a pattern without drawing sketch. But the best beginning to think through all the details of the drawing, executed on a sheet of paper an outline of the future based on the actual size of the composition. So it is more convenient to work out every nuance and make the necessary changes to the sketch.
Operating procedure:
- Prepare patterned figure.
- A cloth material on the work of the board expanded foil.
- Apply drawing, and a pencil or pen to outline sketch circuit. To achieve precise drawing pattern on the foil. Drawing is allowed on the reverse side of the workpiece. You need to know - the bulge is a mirror image manifestation of what regards the starting pattern. To avoid this, you must perform a sketch on tracing paper, then turn face down and trace the contour, forcing the picture on the foil.
Then start stamping. Prior to joining better put a hard rubber, which will be easier to perform tricks extrusion.
- Take a pen with refill.
- Push in the workpiece with small touches of grooves.
- Then awl with a rounded end to align the notch and put them together in a single line.
- When you have finished, turn the workpiece face. If you look at the result, it can be seen that the convex pattern even without clear contours and not finalized. That's why he needs a separate treatment.
Subsequent embossing step is performed on the front side of the form. Here it is necessary to push the background that will enhance the prominence and give miniature clear outlines.
- To work out the relief image of the need to take appropriate masher.
- Gradually increase the pressure.
- Should achieve the desired embossing depth. It's worth noting that the embossed image processing is performed as a result of stretching, and hence thinning of the foil. Attention is drawn to the fact that too thin a layer sheet may tear.
- In operation, there is a constant need to invert the sheet, working through both sides. Because to bulge appeared at the front of the work, it is necessary to put pressure on the back side. On the contrary, the deepening of the picture comes out, if you put pressure on the front side.
- Study begins with the major components and the transition to smaller elements.
- Processing terminates the application of the little touches a picture and then a scenic background design.
- Most often, the background made of grain, imposing on it a plurality of point dents. This gives a picture expressed by the contrast.
Ready relief miniatures, mostly, gets a particular rigidity. But sometimes this is not enough. Sometimes it, for example, are used as a decorative plate on the cover of the book or album. This frame is very simple crush badly. Lest the bitter disappointments of vain effort not to spoil a masterpiece, it must be strengthened. For this purpose, there are a few proven recipes.
The first:
- casein to prepare an aqueous adhesive solution,
- sleep there chalk or tooth powder,
- podsypaya chalk and constantly stirring, bring the mixture to the consistency of sour cream
- add varnish or oil paint.
Second:
- put into a metal bowl wax and resin in a ratio of 2 parts to one,
- heat to heat to melt and mix.
Ready-mix thoroughly before use stir. Pour the finished crafts from the wrong side. When the solution is solidified, wallpapers be mounted on the base.