Content:
- When should I wash the whitewash?
- Preparing for operation
- Washing with water
- Scraper
- Cleaning with adhesive
- Using
- paper
rinsing solutions Any repair begins with surface preparation. And then we have a question - how to wash whitewash from the ceiling and in what cases is it necessary to do it? The very process of removing whitewash is not too complicated, but due to the fact that the field of activity is above your head, and even at a decent height, there may be difficulties. Recommendations from experienced craftsmen will help remove chalk and remove the old whitewash with minimal effort and time.
When should I wash the whitewash?
It is clear that if it is planned to install a suspended or stretched ceiling, then it is not necessary to remove the old whitewash and chalk. An exception to the rules will be the situation where mold forms formed on the ceiling. In this case, all chalk should be washed and surface treated with a fungicidal compound.
You also need to remove the whitewash in the following cases:
- before wallpapering;
- when painting with water-based paint;
- before facing with expanded polystyrene tiles.
If you plan to simply refresh the finish, then you can leave the old chalk. In this case, it will be necessary to re-whitewash the ceiling approximately with the same composition that it was whitewashed earlier. At the same time, there should be no spots of grease, mold and dirt on the surface - otherwise all this will show through fresh repair.
Board
Find out which whitewash was applied to the ceiling, you can use a simple test. On the surface sprinkle with water - if the drops are absorbed, then this is chalk, and if they remain, then whitewash is limy.
Preparing for operation
Washing the ceiling of the whitewash - the occupation is rather dirty. Therefore, furniture is taken out of the room, and the remaining items are covered with a polyethylene film. Cover the floors with cardboard or newspapers.
Prepare the appropriate equipment: overalls, a hat on the head, goggles and rubber gloves. If you are going to remove the old coating in a dry way, then use a gauze dressing or a dust mask to protect it from dust.
You will also need a stepladder, a bucket of water, sponges, rags and some tools.
Wash off with water
How to remove whitewash from the ceiling? The simplest and most reliable way is to wash the chalk with water. To do this, you will need a large foam sponge or a cloth from cotton fabric, a bucket of warm water and a stepladder. Simply moisten the sponge and with its help clean the ceiling of chalk, dust and dirt.
However, with this method you can get rid of only chalk whitewash.
Scraper
How to clean the ceiling of a whitewash made from lime? To do this, use a spatula.
- Before you remove the whitewash, it must be moistened with water. This can be done with a foam roller or spray water from a conventional manual spray gun. For the treatment of large areas, you can use a sprayer or nozzle on the vacuum cleaner( a special device that is worn on the vent hole).
- Allow the water to soak for 10 minutes.
- To remove the old coating, use a spatula. It is advisable to have at hand two tools - narrow and wide.
- A well-moistened whitewash will be easily peeled off the ceiling. If the solution flows over your hands - let the surface dry a little, if dust forms during the cleaning process - moisten again.
Board
To whitewash easier to wash off, apply with a roller soap solution made according to the following recipe: for 10 liters of water 5 tablespoons of soda and two tablespoons of shavings of laundry soap.
Cleaning with
paste How to wash whitewash from the ceiling with minimal damage to the room? The answer is - use a paste or cheap wallpaper paste!
The paste is cooked according to the following recipe.
- For 1 liter of water take 1 tablespoon of flour. The flour is bred in a small amount of warm water, then poured into a saucepan with boiling water. After cooling, the paste is ready for use.
A paste is applied to the ceiling with a roller. After about 10 minutes it will dry up, and it needs to be removed with a spatula together with whitewash. The old covering will be separated by pieces, without dust and dirt.
Tip
When removing whitewash from the ceiling, a small plastic tray can be attached to the trowel. In this case, the pieces of the coating will fall into it, and not on the floor.
We use paper
To remove old whitewash newsprint will help. Sheet of paper paste on the ceiling with the same paste or wallpaper glue. One corner is left unattached, so that you can take it by hand and take it off. After drying, the paper is ripped off the ceiling, along with it falls off and the old coating. Finally, walk on the ceiling with a wet rag, using a mop. Spots of dirt cleaned separately with a spatula.
Solutions for washing
To wash the whitewash from the ceiling, you can use special adhesive solutions for washing, sold in construction stores. After applying such a solution to the surface, chalk and calcareous compositions are crusted, which is easily removed with a spatula. Without dust, but dirt still can not be avoided.
You can prepare solutions for washing at home. Here are a few recipes.
- Five liters of water take two bubble bath caps and one tablespoon of vinegar.
- Chalk is easier to remove using a 10% solution of table salt. To do this, in a bucket of water, dissolve 1 kg of table salt. The solution is used in a warm form.
After the old coating is removed, the ceiling is rinsed with warm water using a sponge, a cloth or a mop. Checking the quality of work is very simple: swipe on a dry area with your hand - there should not be a white trace on it.
So, how quickly to wash off whitewashing from the ceiling, you now know: at your disposal are several ways. If chalk is used for the coating, it can be removed with a sponge and water. Lime whitewash should be removed with a spatula, pre-moistening the surface. To facilitate the process and prevent the formation of dust, use special flushing or prepare a similar solution yourself.