How do I set up a TV tuner on my TV?

The TV tuner serves for processing broadcast signals in a variety of modes of transmission of the above-mentioned to the image output device. Such a device will allow you to watch different channels in excellent quality. Most modern TV models are equipped with similar technologies. If it happened that you do not have such a TV, do not rush to buy it. TV tuner can always be bought and connected. These devices have different parameters and price, but they have the same configuration principle. So how do I set up the TV tuner on the TV?Let's look at this process in this article, will it be difficult?

to the contents ↑

Setting up the "external" device

For installation you need:

• the TV itself;
• remote controls from it and "consoles";
• antenna, which can be a normal room.

To configure the TV tuner on the TV, you need to do the following:

1. First, check the integrity of the device that you purchased. Install the batteries in the control panel, make sure it is working properly.
2. Find the right place to install your tuner. Connect the antenna to the corresponding connector on the console.
3. Connect the components with the cord( tulip) that comes with the kit.
4. Apply power.
5. Connect the TV to a power outlet.
6. Go to the menu using the control panel for the tuner, select "Search channels" and confirm your actions with the "OK" key.

The device will do it on its own.

to the contents ↑

Setting up the built-in tuner LG

How to set up the TV tuner on the LG TV?Nothing complicated! It is not necessary to call a master for a large sum of money for such a simple procedure. Just follow the detailed instructions.

We classify the configuration of the built-in modules according to two criteria: fast and long. Which method is best suited depends only on the model of the device.

Fast way:

• Go to the site of a TV company that provides communication services in your region.
• Here you can find the parameters that you need to configure.
• In the settings, find the "Channels" menu.
• Find and set the mode of "Cable TV" - this will change the type of reception.

Important! This item may not meet the requirements of your model. If a problem occurs, you should review it in the attached documentation.

• Search for "Manual Tuning" and select it.
• In the window that appeared before you, set those parameters that you saw on the site.
• Run the search.

Check the result, most likely, you can already enjoy a quality viewing of the programs. But if you are dealing with newer models, then read on.

Long setup

With TVs equipped with the "Smart TV" function, everything is slightly more complicated:

1. Switch to the settings mode with the home key.
2. In the "Options" menu, set the country and region in which you reside.
3. In the settings you need to find the "Auto Search" window.
4. In the window that opens, select the type of transmission - "Cable".
5. If all actions are completed without errors, then set a quick search and enter the following parameters:
   • The starting frequency is 274 kHz.
   • The final frequency is 770 kHz.
   • Modulation set to 256.
   • The transmission rate is 6750.
   • Network ID select "Auto".
6. The TV may require some additional information. For the consent put a tick.
7. Proceed to the search. After 15-30 minutes, all available channels will be displayed.
8. In order not to reconfigure over and over again, you can set the auto-update mode in the settings.

If at any of the stages there are problems and detailed instructions that come with the device do not help, consult a specialist on the hotline of the manufacturer's phone.

As you managed to notice, there is nothing complicated in this whole procedure. So why call a wizard, while spending the amount of money that could be put off until better times? Of course, there is nothing for it. Thanks to this article, the problematic question of how to set up the tuner on the TV will disappear, because you already know the answer and applied it in practice.