Why is the washing machine water is flowing from the bottom

The first step is carefully unplug the appliance, in any case, without entering into the water. The high electric current discharge may cause serious consequences and death.

Try to determine the cause of the leak. Drain the water via the drainage pump. If it is broken, get rid of the water by hand. It will have access to the drain filter by removing the bottom of the machine automatic hinged cover. Substitute under the filter and unscrew it.

The main types of faults

There are only a few reasons why the washing machine runs at the bottom.

Water supply hose

To understand where in the drip hose, attach to suspicious places, dry cloth or a piece of paper. Prior to this, be sure to wipe dry with a full hose. This will more accurately determine the location of the break.

drain filter

It may occur due to the fact that the drain cover is tightly pressed. Tighten fasteners, set the spin cycle and check the machine again. Try to keep the filter clean, pulling out accumulated dirt. If it is clogged completely on things will be fine particles of dust and washing performance will drop.

Damage to the dispenser

In devices with vertical loading the dispenser is on the inner surface of the cover, and in front-loading devices it is left on the outer part. It poured detergent. The main cause of the problem: the use of low-quality washing powder, minor injuries or too hard water. Damage to the dispenser shown leakage of water during the Gulf in the tank.

The dispenser may be ejected from the increased pressure in the water supply hose. Damage can be eliminated by adjusting it.

damaged pipes

The washing machine has a set of nozzles, each of which performs an important function. To inspect the pipe, responsible for the supply of water: remove the front cover of the device and check the possible fault location. When the water is leaking from the bottom, you need to get to the pipe, is responsible for the discharge of water. To do this, tilt the machine and look at it, or place it on its side. It does not make any sudden movements, so as not to damage the stiralku.

Flow during the water tank and set in the termination of the flow at the beginning of washing a malfunction in the pipe. It connects the inlet valve and the metering hopper. Inspect the item after removal of the top cover.

seal

The main causes of damage to the gum on the manhole cover:

• for the manufacture of cuffs were used substandard materials;
• effects of poor quality powder;
• frequent use conditions with a high temperature water;
• mechanical damage due to falling into a tank of small objects from pockets.

Cuff has problems with integrity, if during the wash through it fly spray or drips of water.

The drain pump or tank

When the washing machine is leaking from below, view tank for cracks therein, which occur due to penetration of solid objects.

If there is no visible damage to the tank, but the liquid out of it still follows: try tighten the screws, which hold together all the components of the container. Remove the drain pump, clean and reinstall. Repeated water flowing to the need to replace the item.

other causes

Among other reasons for failure typewriter isolated fault gland leakage of water from under the door and out of the tank, if it is too overloaded with heavy linen.

Trouble-shooting

There are solutions, depending on the problem. You can try to correct the shortcomings of yourself or seek help from a professional master. Consider how to troubleshoot without assistance.

If the water supply hose burst near the body, eliminate breakage can with a rubber gasket. If leakage is detected on another site, experts recommend to replace the entire hose is new. Glued patch over time pressed out under the influence of water pressure. As a result, the repair will be useless, and the time spent in vain.

flow nozzles can be removed on their own. Depending on species, follow these steps:

1. 1. Pipe, which supplies water to the tank, remove from the body. Two surfaces thoroughly clean, dry with a hair dryer or dry.
   2. Apply glue to the tube for rubber and reinsert.
   3. Securely using sealant tape or epoxy. So far, all the materials are dry, do not start washing.
   4. Two other pipe repair only by tightening the clamps. If the water is still running from the machine, replace the tube.

1. Repair dispenser slowly pulling it from the instrument and purified from adhering powder. Verify whether the treatment has helped, including the machine into a power outlet.
2. Leak water from the bottom of the machine may be due to the seal. Remove it from the hatch and carefully inspect. Small defects, remove or replace the patches gum.

If there are any cracks in the tank, do not try to close up or gloss over them. Give the car to the service center to correct such failure.

Flow into the bearing area to repair the home is virtually impossible. To do this, you need to change it with the gland using a special tool.

Prevention of problems

To face the problem of less flow of water from the bottom of the washing machine, follow the preventive measures:

1. Every six months, clean from scale instrument. For this purpose, special means are suitable or citric acid: Fill 3 of the sachet into the powder compartment, set temperature 90 ° turn and washing without things. Drum, pipes and clean the heating element from limescale.
2. Fall asleep to the device only quality besfosfatny powder.
3. Before downloading things lay everything out of your pockets. If a product has a metal button or a snake, turn it inside out and put in a special bag for washing.
4. Use the water is not increased rigidity, filters and softeners.
5. To protect the seals from rapid wear and destruction, rarely wash at 90 °.
6. Dry the device after each wash, clean the filter, wipe the outside of the machine: door, side walls and a bottom.

To less to repair the washing machine, do not allow the causes of breakdowns. Periodically inspect all components, take care of them and use a good quality detergent. Spending more money in use, you can avoid further trouble.