Problems with the refrigerator door can lead to tragic consequences: on the walls appear condensation, frost, there is an unpleasant smell. In this situation, users are thinking about replacing equipment or called masters at home. repairmen services do not come cheap, and repair the refrigerator door can be done independently.
One of the disadvantages in the device can be tight opening door of the refrigerator. Basically, this problem occurs with frequent opening and closing doors. the principal the reason for this is downtrodden drain hole.
Drainage outputs the condensate outwardly maintaining the required humidity level in the chamber. Moisture drains into the sump which is below the refrigerator and is not actually integrated into the structure. Due to this, the drain tube connects the internal volume of the device to the outside of the room air.
the inner volume is closed when clogged holes. Permanent opening of the doors leading to the ingress of warm air inside the chamber. Thereafter, the air is cooled and shrinks. The internal pressure decreases, and the external atmospheric pressure presses the door, and she begins to open up tight.
Additional unpleasant manifestation hammered holes - the accumulation of water on the floor. When the problem with the door accompanied by the formation of puddles, you should immediately clean the drain. This can be done with a brush, which comes complete with a fridge. If you do not, use a plastic scribe. When not clogged hole and tube - clear it will help thin stiff wire. If cleaning does not help, check the pipe for water drainage. It may move or may be something to squeeze.
Adjusting the slack
Another common problem - sagging door. It occurs due to improper transport or when overloaded hinged side shelves. This defect also requires immediate removal, for infringement of tightness in the cell leads to spoilage.
If slack refrigerator door, it can be adjusted using plastic shims. they are selected individually for each model.
Proceed as follows:
- It is necessary to release the door from the food and take it apart.
- Unscrew the top panel. This is easily done by removing the fasteners from the top.
- Next you need to remove the door.
- On the lower hinge pin placed washers. Their number depends on the level of sagging.
- The door back into place.
- Checked fit gum and light work.
If any damage before repairs need to read the instructions. In detail it describes a process for adjusting the refrigerator doors.
If creaking
The creaking of the door - not a serious problem, it is easy to correct yourself. Each refrigerator door practically hanging on two hinges - on the top and bottom. Erasing them lubricant leads to creak when opened.
Correct the defect can be as follows:
- Determine the loop jarring when opening and closing.
- Lubricate hinges special means: paraffin wax, petroleum jelly or mineral oil.
- Open and close the door several times before the disappearance of the squeak.
These actions do not so simple. The process hinges lubrication is:
- Refrigerator door is completely free from objects that are stored in it. Then it should be possible to lift the hinge to the details were freely available to the application means. In such a case will not prevent assistant, as the door can be quite severe.
- For lubrication you can use any of the known means. They are sold in every domestic store or market. Do not skimp and do not take other oils. The funds are not intended for lubrication, can get into the food stored in the refrigerator. This will negatively affect the taste, odor or appearance of products.
- Lubricant is applied to the lower part of the hinge and spread over the entire length. If you raise the door higher, it will be easier to distribute the agent evenly. To facilitate the process, you can use a small flat screwdriver.
- Finally, the doors need to be opened and closed several times before the disappearance of the squeak.
This work is best done in rubber gloves. When you save the unpleasant sounds have to remove the door and hinges with petroleum jelly. As a means to lubricate very important - the better the product, the less need to use it.
Periodically creak also occurs in the absence of defects in the refrigerator. Sometimes it appears in the first few days of using the machine, is that it is worn out the rubber seal. In a situation creak when it becomes too loud, it will be better to turn to the master.
proper use
The overwhelming majority of problems with a refrigerator occurs due to careless operation. When using the equipment, take the following precautions to prevent its replacement:
- You should not slam the door. Cover it carefully.
- Frequent peeking in the fridge seal leads to microfractures and difficulty opening the door.
- As a preventive measure, lubricate hinges once a year. This will prevent the occurrence of unpleasant sounds when opening and closing the door.
- Do not overload the side door.
- If your unit with dropping defrosting - timely defrost it.
- for seal care should be carried out regularly: it should be cleaned with warm water, dry thoroughly using talc, lubricate. Due to the observance of these simple actions the seal will not have to change often.
Do not ignore the rules and the refrigerator will last as long as possible.
