🐠 Akvamir in the glass: like their own hands to make a terrarium with waterfalls

Painting with wildlife or good pictures adorn the interiors of many apartments. The thing is that natural beauty can enjoy forever. Especially attractive look landscapes with ponds and waterfalls: they have so much vitality! What would you say if given the opportunity to receive not only three-dimensional model of a luxury landscape, but also fully operational, in the natural world: a pond, waterfall, rocks, green and even light fog? Yes, in front of such exposure can meditate twenty-four hours without a break, admiring the play of reflections on the water. And, by the way, to make a decoration for your interior is quite possible to their own hands. Proof of this - the work of the author YouTube-channel Asu.

Read article

1 What will it take to create Akvamir
2 frame assembly aquaterrarium
3 Decorating Akvamir natural materials
4 Water filtration in the terrarium and fog

What will it take to create Akvamir

First of all, the aquarium will need to create Akvamir. It is better to choose a rectangular shape - in her whole landscape will look like without distortion.

To do Akvamir two waterfalls need a tee, which is used plumbing

On both sides of the tee, connect the hose: corrugated or conventional, silicone or plastic - the material is not so important

To work waterfalls need a small aquarium submersible pump. The pressure should not be large, so that the power device is not required. Well, if the capacity of the unit can be adjusted. Tee with hoses attached to the pump

Another specific device constructions - mist generator. It is a small motor that turns the water into a fine slurry. Such devices, but larger in size, operate in humidifiers

In addition to the above, please be a piece of matte film, plastic foam or a pair of plates which are used for papering ceilings, a set of natural stones and tiny living plants that love moist environment. To keep the water clean, you will need concrete block or a biofilter.

frame assembly aquaterrarium

Assembling structure begins with the installation of the pump.

The pump is placed at the center of the tank and hoses are attached to opposite walls using the suction cups

Check the pump operation: type of water for about a third of the aquarium and turn on the device: one is to raise the water to the desired height without problems

Wherever you put your terrarium is not good if the back wall will shine through and it will be visible wallpaper or your situation. To this did not happen, a rear wall better cover matte film or any other material which will hide the contents of wall

Now the tank for your little world is ready, it is time to proceed to registration.

To create a framework for future rocks need to cut out of plastic or foam base. What will it be - you decide, it's totally a fantasy object

The only thing that is important - in the bottom part must have openings for water extraction, preferably with a medium-sized mesh, and on each side - elevation, which will be located waterfalls

Assembling of the carcass by means of a silicone adhesive to the aquarium or silicone sealant, which essentially is the same composition. It is to glue all the details, and firmly stick the entire frame to the bottom and walls of the aquarium.

Decorating Akvamir natural materials

To your landscape looked like a possible naturalistic, pick up these stones.

Stones better to take the rough and sharp edges in the rocks. Well, if the rock will have blotches and different shades

Using the same adhesive fix the stones on the frame as tightly as possible to each other, creating a natural ridges and peaks

That the stones do not show through the foam, fill the gaps with silicone and sprinkle sand or fine rock dust

While silicone is not dry, gloved finger primnogo sand, so that it is well stuck, and after drying sweep up excess with a soft brush

On several horizontal platforms place the fertile soil, mixed with a small amount of clay and bark

This soil will be the basis for plant nutrition. You can use the mosses, lichens or plants that feel good in humid climates, such as asparagus plumose

Over time, the mosses are comfortable in a new place, start to grow and will look very natural

To decorate, use a shallow pond duckweed, and she quickly razrastotsya will flicker on the surface of a green carpet

Water filtration in the terrarium and fog

It remains only to solve the problem of clean water, because it is constantly changing - hard work, can cause damage to the entire work.

In the rear part of the structure is not visible from the pediment, pour concrete block or a biofilter. You can use a special aquarium sponge

Some are used for this purpose, even an ordinary sintepon

To create haze in one of the elevations for waterfall placed mist generator

Aquaterrarium ready: in front of you a living landscape with a waterfall, a light haze and lively greens

Creating such a structure - a creative process that does not tolerate haste. The more fine detail and carefully study them, the more natural it will be the result. This work will want to enjoy your family and guests, so do not make mistakes. For plants will be enough natural moisture Akvamir not necessary to water them. It is only necessary to monitor the purity of water and from time to time to pour it, because it will evaporate the fog.

And how do you like the idea of the author? Would you like to have at home a living landscape? Maybe you have already made their own hands something like that? Here is an example of one such terrarium by a professional team in a small video:

Please send us your impressions in the comments, as well as master classes for the category "not a woman's business"!

Photo: YouTube-channel "Asu«

🐠 Akvamir in the glass: like their own hands to make a terrarium with waterfalls

What will it take to create Akvamir

frame assembly aquaterrarium

Decorating Akvamir natural materials

Water filtration in the terrarium and fog

About us

Categories

Latest